Photovoltaic mounting products installed in the transport process of these points, you should notice it!

With the continuous development of photovoltaic power generation technology, photovoltaic bracket products, as an important part of the photovoltaic power generation system, is also getting more and more attention. In the installation and transport process of PV bracket products, the following aspects need to be noted:

First of all, PV bracket products need to pay attention to preventing collision and friction during transport to avoid damage to the product surface. When loading and unloading, professional lifting tools should be used to avoid the products being squeezed and collided, resulting in deformation or damage of the bracket.

Solution: In order to avoid the zinc layer of galvanised steel pipe falling off, some effective solutions can be taken.

1. in the production process, strengthen the operation management of galvanising equipment, ensure that the temperature of galvanising bath, zinc salt content and so on are in accordance with the specified requirements, in order to ensure the quality of zinc layer of steel pipe;

2. In the process of transport and installation, the steel pipe needs to be properly protected to avoid shedding. Packaging materials can be used to strengthen the package, while adopting suitable transport methods to reduce the collision and pressure on the steel pipe; during installation, attention also needs to be paid to protecting the surface of the steel pipe to avoid any damage.

3. For the situation that has occurred the zinc layer off, before re-galvanising, the surface of the steel pipe needs to be weld cleaned to remove impurities and improve the surface cleanliness, and in the case of ensuring that the surface is dry, welding and re-galvanising.

In short, to avoid the situation of zinc layer shedding of galvanised steel pipe, it is necessary to strengthen the management in the production, transportation and installation process, and take effective protection measures. At the same time, the solution to the zinc layer off is also a variety of methods, need to analyse the specific situation, choose the appropriate solution.

Secondly, photovoltaic bracket products in the transport process need to pay attention to prevent moisture and direct sunlight. Especially in the summer high temperature weather, the product is exposed to the sun for a long time easily lead to the aging and deformation of the bracket material. Therefore, in the process of transport should choose shade and well-ventilated vehicles to avoid direct sunlight on the product.

Tips for storing galvanised products in rainy season

Summer hot weather, more rain, and rain after the weather is more hot and humid, galvanized products in this state, the surface is easy to produce alkali (commonly known as white rust) phenomenon, therefore, old and new users friends, about some galvanized products in the rainy season storage of common sense must be aware of Oh!

Rainy season galvanised products storage conditions

1. Try to store indoor or thatched cover in rainy and foggy weather, and remove the sheeting to keep it ventilated and dry after the rain stops and the fog disperses; 2.

2. Avoid direct contact with wet soil when storing.

Treatment of galvanised products in water and moisture

1. In case of water ingress into the whole piece, it should be dismantled immediately and placed in a ventilated place to dry.

2. If there is slight white rust or spots on the surface, it should be dismantled immediately and dried in the sun, and wiped off in time after the white rust becomes powdery, and then covered with hot-dip galvanised manual spray paint, which will not affect the rust prevention.

Spraying will not affect the antirust effect.

Attention!

Galvanised products are not afraid of rain, but afraid of covering! If the whole product into the water, in 1-2 days time will produce white rust, please the majority of users and drivers friends to pay attention to timely damage avoidance.

In general, photovoltaic mounting products in the installation and transport process need to pay attention to the protection of the product surface, to avoid moisture and direct sunlight, as well as to avoid excessive external forces. Only in this way can ensure that the PV bracket products can operate normally after installation, and play the maximum power generation benefits. I hope that the above points of attention to help you in the installation and transport of photovoltaic mounting products.